Electronics factories, petrochemical plants, high-tech factories, etc., often have demand to increase or change pipeline; once the pipeline stops working in production stage, the loss is huge. No stop changing operations (Hot Tapping / Line Stopping), can be performed, such as changing, repairing, and blocking under normal production operations.

 

HOT TAPPING

Hot tapping or pressure tapping is the method of making a connection to existing piping or pressure vessels without the interrupting or emptying that section of pipe or vessel. This means that a pipe or tank can continue to be in operation whilst maintenance or modifications are being done to it. The process is also used to drain off pressurized casing fluids and add test points or various sensors such as temperature and pressure.

Hot tapping is also the first procedure in line stopping, where a hole saw is used to make an opening in the pipe, so a line plugging head can be inserted.

 

Introduction

Short-circuit the short tubes on the pipe fittings of the specified flow material and apply them with the HOT TAPPING machine.

Drilling and hinged through the main pipe to form a connecting cannula line.

 

Scope of application

1/2"~162"

Characteristics

  • It can be used for live line intubation without parking; saving huge cost loss caused by parking.
  • The construction site can be arbitrarily determined, which can reduce the cost and space of piping materials.
  • The construction is safe and rapid, and it is applicable to many material characteristics (such as water, steam and oil).
  • Flammable materials can be used with LINE STOPPING and PIGGING to make field pipeline block connection modifications.

 

Hot Tapping / Line Stopping

gallery/hot tapping-b

HOT TAPPING

Line stopping or line plugging is a means of isolating a piping system to provide a shut off where none exists. This process serves as a control, or temporary valve, that can be removed after alterations or valve replacements have been made. With a hot tap previously made on a line, a line stopper is attached to a temporary valve, and the valve is opened. The line stopper is hydraulically or mechanically pushed into the line to seal the pipe. The main is supported by the line stop sleeve. After performing the necessary service, the stop is removed, and a blind flange is installed on the sleeve.

 

Introduction

With HOT TAPPING construction, under the no-stop venting, block the raw materials or add bypass pipes to continuously circulate the liquids on the pipe fittings of the specified flowing materials, and apply the pipeline to modify or replace the valve components or repair work.

Characteristics

  • It can be used for live line intubation without parking; saving huge cost loss caused by parking.
  • The construction site can be arbitrarily determined, which can reduce the cost and space of piping materials.
  • Blocking repair, valve component replacement or pipeline modification can be performed in the flow line without affecting production, and will be restored immediately after completion.

 

gallery/line stopping-900